250-500cc wr 250 bearings

which are the #for wheel bearings front and rear for a 2007 wr 250.example 6202 etc.

The parts manual for this bike will have the exact size of the bearings for the wheels in it and you can go to any bearings store and buy them ... Or just carry the old bearings to the store and they can match them up for you ...

Front 2 x 61905-2RS (25x42x9)
Rear 2 x 6005-2RS (25x47x12)
1 x 63005-2RS1 (25x47x16) This one is bloody expensive if you buy good quality.
Alternative is just to buy kit with seals and bearings which are shitty Chinese bearings but very much cheaper and just replace them more often.
I think Pivot Works is better than All Balls.
http://www.motosportzhusqvarna.com/Husqvarna WR,CR 250-300.htm

I just go to my nearest bearing store and buy the best i can afford.

think that should be 6905 for the front bearings.[2RS or ZZ]
On the rear if you are jammed[bearing store closed or out of stock] on the wide bearing for the rear brake caliper side you can deal with it by using two 6005 and an inner race from a used front 6905 on the outside as a spacer, instead of the stock aluminum spacer

thanks steadydirt, thats what im talking about good direct information.

2RS means rubber sealed bearing on both sides, and ZZ means steel sealed bearing, I have ALL BALLS on dirt and supermoto wheels installed (2006 WR 250) and are good price/quality ratio.

61905 and 6905 will both work as they are both 25mm x 42mm x 9mm. I was using the SKF 61905.

Pardon my

Pardon my error. SKF- excellent bearings

no problem buddy