All 2st WR 250 Top Triple Clamp Help

Hi all, does anyone have or know where to get a replacement top triple clamp for a 1999 husky wr 250 either new or used its running 45 mm zokes. im not sure what year will inter change if any.

Scan fleabay man, 250 through many years is the same clamps also 360 02 deffo is.
Good luck

top man cheers bud

Post in the classifieds here too. There's some guys with garages full of parts

125s of same era probly had same clamp too I'd imagine?

A word of caution the CR models will have different offset and pin size.

The '01 and up bikes have a good bit less offset as well, so you'd need both the lower clamp as well if you went that route.

rancher1 is right too, the CR models use a different pin that doesn't work with the WR model.

this brings up an interesting question
the 99 vs 04 triples what is the offset and ultimately handling difference?

I've tried compiling info that's listed on the various repair manuals and by measuring the Triples on my bikes, but it gets pretty complicated with all the small changes Husky made.

I've compared a set of Triples off a '01 WR250, '02 CR125 and '04 CR125. They all have a similar offset, the only difference is the pin size on the CR is larger at the ends & tapered to support the 29mm Stem bearings.

My '00 WR360 and '99 WR125 have the exact same Triples, and the offset is quite a bit greater than the '01+ Triples, at least 10mm more.

If you check out the repair manual on the '99 and '00 250/360 bikes, they list the fork caster (trail) at 100mm and 103mm. The '04 repair manual lists the fork caster at 111mm (CR) and 114mm (WR), since the triples have a bit less offset in them.

Oneal, what is the part number on the bottom of the clamp ?

Rancher the part number on the bottom clamp is 800069319

All sorted the bikes back and running