125-200cc WR Power Valve Gear

Hi All,

When I got my WR it was missing the gear that runs the power valve...was just completely missing.

I have purchased the bit and it fits perfectly but it makes the bike almost impossible to kick over and makes a noise like it is fouling on something even though there appears to be nothing in the way.

The system was all cleaned and is moving freely

Does that sound like a setup issue or am I missing something?

Hi,

I had a similar problem a while back:

http://www.cafehusky.com/threads/1998-cr-125-lacking-of-power.43816/#post-425545

You need to make sure 100% that the gear on the governor is meshing with the gear inside when assembling.

Leave the PV linkage cover off and check to make sure its not trying to operate the linkage when you try to kick it over, is the replacement second hand? It could be faulty and permanently engaged?

Also need to get the positioning right, ie the linkage arm has the be at the right angle as you insert the governor assembly, this allows the small gear on the on the linkage shaft (at top of the opening) to mesh into the slots/grooves on the governor.

Its worth leaving the PV linkage cover off for a test ride so you can easily adjust the setting.


Hope this helps

May help with the set up:

http://www.cafehusky.com/threads/125-power-valve-adjustment-again.9309/

Brilliant, will have a look later...fingers crossed!