250-500cc Wr300 throttle cable APT?

Just picked up a cast 38mm APT from a fellow board member and I'm beyond excited to get it on. He sent me a cable with the carb but it's way short. I had risers and the Scott's damper setup on mine. Not to mention the Kx high bend bars. I've been told the 2001 honda cr 125 cable is like 7" longer then my stock wr300 cable. Any info to help me out woul be great guys!! Thanks in advance!

sweet, post some pics of the install! we dont have many pics of the smart carb installs on here. some info on its workings would be nice as well.

I'll be sure to post some up when I find out the cable I need to get her going...

The honda one shouldn't be expensive, pick one up and get going.

So is this a yes for the honda cable working?

Looks like the motion pro 10-3000 cable is perfect! Does anyone have any good info on break-in. I know I'll be running the 32:1 mix but idk for how long or what throttle conditions. Any help would be greatly appreciated

Break in on a 2011 WR300? It's not a used bike?

New piston and the cylinder was just done

run the oil mix you plan on always running. not much break in on a plated topend. i would still avoid high rpms or heavy load for an hour or two. some guys give it hell right away on plated topends

You should always do at least one heat cycle. Start it and let it warm up completely without revving it up too high then shut it off and let it cool completely to room temperature... that equals one heat cycle. I usually do this as soon as the engine can be run and then spend the cooling time checking everything else.