1. 2 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     WR = 2st Enduro & CR = 2st Cross

250-500cc Wr360 clutch adjustment screw procedure

Discussion in '2 Stroke' started by VTwr360, Jul 25, 2013.

  1. VTwr360 Husqvarna

    Husqvarna Motorcycle:
    2002 wr360
    Other Motorcycles:
    06 klx300r, 08 klr650
    So I've got the clutch back together and am having trouble setting the adjustment screw,it seems no matter wich way I turn it I can't get the 1-2mm of idle stroke. I seem to have way more . Any thoughts ?
    VTwr360, Jul 25, 2013
    #1

  2. Dirtdame Administrator

    Location:
    Rock Springs Wy
    Husqvarna Motorcycle:
    11 WR300,13 WR125,18 FE501
    Other Motorcycles:
    17 Beta Xtrainer
    If it's like the one on the WR300 clutch, turn it in till it bottoms, then turn it back out a quarter turn and lock it. See if that helps.
    Dirtdame, Jul 25, 2013
    #2

  3. VTwr360 Husqvarna

    Husqvarna Motorcycle:
    2002 wr360
    Other Motorcycles:
    06 klx300r, 08 klr650
    It has a slot in the pressure plate and one behind th lock nutt with a screw like bolt in the middle
    VTwr360, Jul 25, 2013
    #3

  4. juicypips Husqvarna
    Pro Class

    Location:
    gloucestershire
    Husqvarna Motorcycle:
    wr 360. 2002
    Other Motorcycles:
    Gas Gas TxT 300, Yamaha wr250f
    i use two flat heads and a ground down 10mm, i unlock the thing then wind it in till it feels resistant, pull the clutch leaver then keep backing it of untill you can move the leaver about 3mm before they plan to move, slot the flatblade in the clutch cutount and wind the nut onto it, make sure the blade of the screwdriver sits under the clutch cutout as you tighten the nut onto this, if you leave your cable adjuster half way the fine tuning if youve nipped it up too far or under done it may be able to fix it, i just do a lot of lever wiggling untill it feels right.

    good luck
    juicypips, Jul 25, 2013
    #4