DErZ
Husqvarna
A Class
In the next couple of months I will hit the 5000 mile mark at which point I thought I'd get the head ported and polished and while its in bits I'll replace the piston.
I was looking at the ProX piston (Type B) http://www.24mx.co.uk/prox-piston-1/husqvarna-te511-2011
Does anyone have any recommendations other than the above?
Also I suspect Ill need a head gasket
http://www.athenaparts.com/eng/products/view/19714/cylinder-head-gasket
What else is recommend while doing this work?
I was looking at the ProX piston (Type B) http://www.24mx.co.uk/prox-piston-1/husqvarna-te511-2011
Does anyone have any recommendations other than the above?
Also I suspect Ill need a head gasket
http://www.athenaparts.com/eng/products/view/19714/cylinder-head-gasket
What else is recommend while doing this work?