1. 4 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     TE = 4st Enduro & TC = 4st Cross

'12 TE310 and iBeat

Discussion in '4 Stroke' started by Mike-AK, Sep 15, 2013.

Page 2 of 2

  1. everfree Husqvarna
    Pro Class

    Location:
    Bend, Oregon
    Husqvarna Motorcycle:
    86 430AE (2), 88 430AE, 87 430WR (2)
    Other Motorcycles:
    87 250 XC, 87 430 CR, '17 GG 300

    I think you're right. I'll have to find that old thread again.
    Thanks.
    Dave
    everfree, Sep 20, 2013
    #21

  2. starter Husqvarna
    AA Class

    Husqvarna Motorcycle:
    2009 TE310
    Other Motorcycles:
    Buell XB9R, KTM 300exc, Ducati m797
    Has it been determined if iBeat will run in windows compatibility mode 32bit on a 64bit operating system?
    starter, Dec 14, 2013
    #22

  3. reveille Husqvarna
    Pro Class

    Location:
    Northern Illinois
    Husqvarna Motorcycle:
    2014 FE501
    Other Motorcycles:
    2015 300 XC W
    Does iBeat software just come in 1 version or? I have a 2012 TE310 so would any iBeat software cable and interface work with my bike?
    reveille, Mar 6, 2014
    #23

  4. reveille Husqvarna
    Pro Class

    Location:
    Northern Illinois
    Husqvarna Motorcycle:
    2014 FE501
    Other Motorcycles:
    2015 300 XC W
    Does anyone have a iBeat disc they want to sell? I bought a USB serial adapter, driver CD and USB cable from an inmate. I was able to install the adapter but am now in need of iBeat. TIA
    reveille, Mar 10, 2014
    #24

  5. Mike-AK Husqvarna
    Pro Class

    Location:
    Alaska
    Husqvarna Motorcycle:
    2012 TE 310
    Post a pic of what you got. All my software was on a single disk with a Mikuni label on it. I bought it and the cable together as a kit from SEMCO Designs for a little over $300. Pricey but essential in my opinion.
    Mike-AK, Mar 10, 2014
    #25

  6. reveille Husqvarna
    Pro Class

    Location:
    Northern Illinois
    Husqvarna Motorcycle:
    2014 FE501
    Other Motorcycles:
    2015 300 XC W
    I think I got it working now...
    reveille, Mar 10, 2014
    #26

  7. reveille Husqvarna
    Pro Class

    Location:
    Northern Illinois
    Husqvarna Motorcycle:
    2014 FE501
    Other Motorcycles:
    2015 300 XC W
    So it is working good now (iBeat software) All of my CO's are set to 100. I have the TXC ECU and 12 hole and a full FMF powerbomb and RCT 4.1 along with the open airbox and Lambda pulled and terminated. Any CO suggestions for me with the current setup? It runs good as is and I had Halls do the ECU install but since then I added the FMF exhaust so I would like to dial it further if possible.
    reveille, Mar 10, 2014
    #27
Page 2 of 2