All 2st 2 stroke throttle recall for Husky?

I think 11 was a good year!

Mine is a 2013 WR125 !!! Got a message today from my local dealer sayin the part has gone onto factory backorder.

I KNEW I was right. how long we gotta wait? what other throttle assemblies would work?

MINE appears to be the good one. however my cable at the very end where it connects to th throttle tube has quite a kink in it. could be the cause of my troubles. could some one post pics of proper cable routing? thanks

I got a letter today in aus, says forcast arrival date is currently 23/5/13.

My letter arrived today as well

Is it just me or does the housing without the ridge also look like a poorly manufactured version? To me it looks like a loose cast.

Just checked mine, spewin, no ridge.
Good fun working on it though, this bike gives me a horn looking at it, working on it or riding it.

I've had one big over-rev problem on my bike. Figured out the cable was getting caught on the triple clamp when I turned the handlebars and pulling tight to open the throttle. I changed to a 2" longer cable so it can be routed as I want it without getting caught on anything and the problem went away. File this one under the "mis-routed cable" category.

Stuck throttle would be a good topic for a thread. How you responded, interesting and hopefully non injurious details of the experience etc.

I checked mine tonight and it has the so called defective housing. The ridge is needed but I think I may have fixed the cable snagging issue for the time being. It appears that there is possibly too much movement up and down in the white roller. I put a thin washer in between the top of the roller and the flanged brass bush to restrict vertical movement when the cable is being pulled.

Guys, this ain't a big deal.

I had my throttle stick open on my WR a few times when it was brand new. Turns out there was too much slack in the cable and it would "fall off" the white plastic roller when the throttle was fully closed.

Took some slack out, and a few hundred miles and many rides later it hasn't done it again.

Just adjust your throttle cables correctly and stop worrying!

i like to have just a little free play, a mm or 2. i think thats what happened to me. i took all the free play out. that can be a problem as well. when ur tired your hand can blip the throttle on its own. nice to have a little play

It IS a big deal if you have a faulty '13 throttle housing. The issue with your '12 might have worked but tightening the throttle cable on the faulty '13 Domino throttle will NOT keep the cable from getting past and under the wheel due to the lack of the ridge. Kinda scary advice given that people have already been injured seriously because of the faulty housing.

I installed my new housing last night. Its not just the housing that is different but also the the white roller and brass bush have been changed as well.