2008+ Neutral light warning messages

Discussion in 'EFI/carb' started by SwitchThrottle, May 6, 2009.

  1. crancky1 Husqvarna
    AA Class

    Location:
    Wallendbeen
    had this issue with the flashing neutral light,
    it was the relay,
    replaced with after market unit from electrical shop, the dealer wasn't confident he would get a genuine replacement relay in under 4 weeks, so he went with the aftermarket bit.
    all seems ok.

    can somebody please tell me what a flashing fuel light means,
    seems to happen when i have a hot stall and I fail to get it fired up first go (thinking the auto decomp might be faulty)
    i don't have a manual to look it up,
  2. mtne Husqvarna
    AA Class

    Location:
    Denver
    Husqvarna Motorcycle:
    08' TE610 + 08'TE610 sumo'd
    Other Motorcycles:
    KTM 950SE
    Damn, just put things back together from a valve adjust and I'm now getting a cranking no start condition and can hear the fuel pump prime.

    Neutral light flashes four times and holds

    Edit to clarify - three short flashes and holds on the forth.......

    I've been trying to decipher the multi-language manual but haven't found anything about codes.

    Anyone know what that means?
  3. seymore Husqvarna
    AA Class

    Location:
    Boise, ID
    Check the wiring on the ignition coil. I have seen the quick-disconnect terminals get loose and easily slide off.
  4. mtne Husqvarna
    AA Class

    Location:
    Denver
    Husqvarna Motorcycle:
    08' TE610 + 08'TE610 sumo'd
    Other Motorcycles:
    KTM 950SE
    ibeat shows failure

    Manifold air temp - high value
    Manifold pressure - low value
    Throttle Position - low value

    Also I should verify that the white plug I think should be empty is suppose to be that way.

    [IMG]

    As well I've checked the coil connections and they are on tight but in fact when I put a plug in to check spark I get nothing...... the tank is off so could that be it?
  5. seymore Husqvarna
    AA Class

    Location:
    Boise, ID
    Is that the white connector that connects to the sensor group on the throttle body?

    Those fault code all come from the same sensor module that is on the left side to the throttle body. If it's not that connector, I would look at the wiring going to it.
  6. mtne Husqvarna
    AA Class

    Location:
    Denver
    Husqvarna Motorcycle:
    08' TE610 + 08'TE610 sumo'd
    Other Motorcycles:
    KTM 950SE
    Thanks Seymore......... Looks like I had a good case of tunnel vision. The white plug goes to the throttle body....... duh. Started right up of course......

    Sigh. Someday I'll catch up on my rest. Or not.