Estimated values for a 1987 husqvarna wr250 and a 1978 husqvarna cr125

I will have to keep digging for a piston. If i had a template or dimensions I can cut this one down i am about to receive. I would like to have the correct piston.

the bottle in the background says it all

Oops, busted again!

Chris, I can give you dimensions from my original piston if it helps?

Oh man! Could you? If it is not too much trouble, yes I would love to get the dimensions.

Thanks,
Chris B

No problemo Chris, just as soon as I get home from the Canowindra Vinduro!

1988 250wr cylinder

The case cover is damaged along with the water pump shaft and impeller and gooseneck

1988 250wr Kick Start Assembly Damage

phil has all those bits for you

The case is probably ok to use, but a replacement water pump shaft and kickstarter pawl and spring would be a must.

Piston measurements of my original Mahle 66.50 piston are as follows,
Measurement A 49mm
Measurement B 64mm
Width of opening 22mm
Height of opening 19mm

This Helps! Thank you very much!

I didn't modify the skirt length, just made the cutout deeper, I like the idea of a longer skirt keeping things square.

looking at the casting number looks like an 85-86
1616370 was on my 87 250 cylinder
did you check the bore?

And mine is 1616379.....
Tony.

The bore was 66.44mm.... this a wiseco piston for the 99-00 model that I pulled out of it.

Have a point of Contact for Phil?

my bad, blew the pic up and it was a 9 not a 0
sorry

I think John means this:

http://www.husqvarna-parts.com/husqvarna_parts_home.html

Thanks, I tried to call and got a message saying that they are not accepting calls at this time so i sent an email.