New to me 2010 TE310, minor problem

Not yet. The mating surface on the cylinder was not perfect (pretty sure it was dropped) and I don't want to deal with the dealer anymore unless I have to so I sent it to a machine shop to get it done right. If and when I get it back I will drop it back in and hopefully the electronics and fuel delivery will work...... This is the longest it has ever taken me to finish a project. I guess this explains why it was such a good deal....haha

So what I forgot to say was that when I was trying to get the mating surfaces to seal I very stupidly over torked the 4 head bolts and pulled them out of the case...... The machine shop has it all ready to go just waiting on new head bolts from husky. I WANT TO RIDE THIS THING ALREADY ! Can I just ride one of your bikes for a while

did you get a workshop manual?

http://www.husqvarnafactory.nl/pdf/2010/2010_WSM_TE-TC-TXC-SMR_310-450-510.pdf

Yep. And the first 2 times I put it togeather I read it correctly the third time. Not so much. Haha.

HAHA... I FINALLY RiDE IT TODAY !!!
first pic is after I dropped the motor in, second is after my first ride around the block

Very nice, how do you like it? I'm about to take on a similar job! Just no where near as bad!

@tepco i really like it. I haven't had much time in the dirt but from the way it feels I think it will do just fine. I do like a challenge but if I were to do it again, I wouldn't. Parts are just to expensive and hard to come by. Now that I type this I change my mind. I would do it again. I think I would have tried to talk the owner down a bit more on the price.