1. 4 Stroke Husqvarna Motorcycles Made In Italy - About 1989 to 2014
     TE = 4st Enduro & TC = 4st Cross

Photos of new 250 motor with valve cover off...

Discussion in '4 Stroke' started by krieg, Nov 19, 2009.

Page 2 of 2

  1. Burnman Husqvarna
    A Class

    Location:
    Quebec
    On my Te 250 2010 under the seat on the sticker the tolerances are there for the valves 0.10mm to 0.15mm intake and 0.20 to 0.25 exhaust
    Burnman, Aug 28, 2011
    #21

  2. JasonfromMN Husqvarna
    AA Class

    Location:
    MN
    Husqvarna Motorcycle:
    None right now :(
    Other Motorcycles:
    2013 Yamaha FZ6R
    Just found my tolerance sticker on the front brake caliper side upper fork tube.
    JasonfromMN, Aug 29, 2011
    #22

  3. Paul B Husqvarna
    A Class

    Location:
    Australia
    Husqvarna Motorcycle:
    2099 TE310 with SHOWA forks
    The clearances are greater than the stated required in the earlier post. Valves close up from ware not open.
    Paul B, Aug 30, 2011
    #23

  4. JasonfromMN Husqvarna
    AA Class

    Location:
    MN
    Husqvarna Motorcycle:
    None right now :(
    Other Motorcycles:
    2013 Yamaha FZ6R
    Good catch. I wouldn't touch those valve unless the 310 specs are different than the 250.
    JasonfromMN, Aug 30, 2011
    #24

  5. R_Little Husqvarna
    Pro Class

    Location:
    NJ
    Careful on the cam bolt torque...use a torque wrench. They WILL strip otherwise.

    I did mine last year and it was cake. The gear driven cam makes is much easier than my Yamaha 5 valve!
    R_Little, Aug 31, 2011
    #25
Page 2 of 2