Race Map II when powered up?

May be electrical issues or wrong/bad connection. Check circuits, see wiring diagram (workshop manual).

Hi
A have the same but without this connector (it was missed before I get the bike) so i have only 2 wires there with exactly same colors as yours, one brown and other blue and brown. And i just connect them one to another, unplug CO sensor connector. And nothing was happened. There is no any Race Map 2 on the dashboard.

Ok I will try but what can be wrong there ?)
Its just simple steps)
Если есть какие-то ещё идеи буду рад выслушать )

Eddy, do you speak Russian?
Берёте электрическую схему (именно свой год выпуска, т.к. 2011 и 2012+ различаются немного), тестер, и прозваниваете цепи от разъёма MAP SWITCH до ECU (сине-коричневый B/Br, на 33 контакт ECU) и от разъёма MAP SWITCH до общей шины VB SG (серо-коричневый Gy/Br, также соединён с 25 контактом ECU). Чудес не бывает!

Huskynoobee,
I don't know, where he is from. No location in his profile. Man of the World!
In English:
See electro scheme of TE449/511 (MY 2011 and 2012+ slightly different), take AVO-meter, and check the circuits: from MAP SWITCH connector to ECU (blue-brown B/Br wire, 33-th pin of ECU), and from the MAP SWITCH connector to a common bus VB SG (gray-brown Gy/Br wire, this wire is also connected to 25-th pin of ECU). Miracles do not happen!

Моё приветствие, да конечно говорю ) Буду пробовать. Дам знать как вышло или нет.

Thanks a lot I will try ) And give my answer soon if it will or will not help _)