Reduced clutch pull on TE310?

worked a treat !!

Well Coffey if it works who cares what it looks like. I have a spare one and feeling like a bit of workshop therapy so will give it a go.
Cheers.

if smaller is better then why they did not used
Magura Clutch Master Cylinder 9.0mm (part Nr 23-012)? https://www.enduroeng.com/ProductDetail.jsp?LISTID=800001E0-1177528269
can you ask Alan of enduro engineering?
and anyone know what is diametr of original magura master cylinder on our husky?

I pulled the two spirngs on my 2006 TE250. I just did an 80 mile enduro a couple of weeks ago with no issues at all, even with a 13 dront sprcket instead of my normal 12, and I am pushing 275 buck neked, let alone the tonange with all my gear on.

actually i've put smaller Clutch Master Cylinder which is 9.0mm (original is 9.5)
and what are DIFFERENCE now!!
clutch now is like was on my trials gasgas.
thank you Alan at enduro engineering!

I pulled 2 springs out of my 310 at the start of the season, and the pull is definitely lighter, but the downside is my clutch is worn out sooner than I expected. I need plates pretty bad and I dont think I am that hard on a clutch.

I am not mad about and I may even pull 2 springs out of my 2010 if it is too stiff, but my experience is that you will wear out your plates sooner.

I PUT MINE BACK IN AFTER ONE RIDE.. SLIPPED LIKE HELL WHEN I GAVE IT THE BOOT ! so not so good on the bigger hp te510 !