Hello,
I was hoping someone could help me out with a problem I'm having with my newly purchased bike. I've read through a bunch of threads on this and performed some diagnostics myself, but am still having troubles.
To start with, on a recent trip, as I was going to get on the highway my engine light came on and the RPM needle was acting very erratic. All this while the bike seemed to be running fine. I turned the bike off and let it sit for a bit before continuing on my way. The same thing started happening about 10 miles down the road after I exited the highway. This time I let it run for a minute and then the EWS error showed up and my bike shut down. I disconnected the battery and let it sit for a bit. I reconnected the battery and it started back up without the error. As I was getting back on to ride away, the error came back and the bike shut down. I repeated the process with the battery, but this time when I started it back up I quickly hopped on and rode away. Everything seemed to be fine when I was at higher speeds, but when I would slow down, I would get the RPM needle jumping around and check engine light to come on. I made it home and did some reading on all of the husky forums.
I ended up getting a new battery, running a ground strap for the ECU to the battery and checked all of the connections under the headlight cowl. The connections all seemed to be fine and the fragile wires to the antenna all seemed intact.
I took my bike for a ride and everything seemed good for a bit until I had the engine light come back on and RPM needle go nuts. So, I ended up getting all of the needed accessories to run the motoscan app. I came up with a CAN-bus fault CD85 error. I did a search for the error, but can not find out what it is. Can anyone help me with my problem.
Thanks, Mike
I was hoping someone could help me out with a problem I'm having with my newly purchased bike. I've read through a bunch of threads on this and performed some diagnostics myself, but am still having troubles.
To start with, on a recent trip, as I was going to get on the highway my engine light came on and the RPM needle was acting very erratic. All this while the bike seemed to be running fine. I turned the bike off and let it sit for a bit before continuing on my way. The same thing started happening about 10 miles down the road after I exited the highway. This time I let it run for a minute and then the EWS error showed up and my bike shut down. I disconnected the battery and let it sit for a bit. I reconnected the battery and it started back up without the error. As I was getting back on to ride away, the error came back and the bike shut down. I repeated the process with the battery, but this time when I started it back up I quickly hopped on and rode away. Everything seemed to be fine when I was at higher speeds, but when I would slow down, I would get the RPM needle jumping around and check engine light to come on. I made it home and did some reading on all of the husky forums.
I ended up getting a new battery, running a ground strap for the ECU to the battery and checked all of the connections under the headlight cowl. The connections all seemed to be fine and the fragile wires to the antenna all seemed intact.
I took my bike for a ride and everything seemed good for a bit until I had the engine light come back on and RPM needle go nuts. So, I ended up getting all of the needed accessories to run the motoscan app. I came up with a CAN-bus fault CD85 error. I did a search for the error, but can not find out what it is. Can anyone help me with my problem.
Thanks, Mike